2h Heavy Hex Nuts Factory Introduces The Use Skills Of Steel St

  •  

    Bolts are connecting parts of steel structure. According to the bearing capacity, they can be divided into ordinary bolts and high-strength bolts. Below, 2H Heavy Hex Nuts Factory introduces the precautions in the construction of steel structure bolts.  

    1. For the bolt connection of dynamic load or important parts, the spring washer should be placed according to the design requirements, and the spring washer must be set on the side of the nut.  
    2. The installation of high-strength bolts should be able to penetrate the holes freely, and forcible penetration is strictly prohibited. The hole diameter of the high-strength bolted steel plate is slightly larger than the bolt diameter, and it must be drilled and formed.  
    3. The scheduled connection of high-strength bolts is usually divided into friction connection, tension connection and pressure connection. Among them, friction connection is the basic connection form widely used at present.  
    4. The installation sequence of high-strength bolts: should be carried out from the rigid part to the unconstrained free end. The high-strength bolts on a joint should be tightened one by one from the middle of the bolt group to the surroundings for the initial, re-tightening and final tightening. Each tightening shall be marked with a different color paint to prevent leakage. The initial tightening, re-tightening and final tightening of high-strength bolts in the same joint should be completed within 24 hours. If there is no prescribed design, it should be carried out according to the construction process sequence of first tightening the high-strength bolts and then welding (ie bolting first and then welding).

    Through the above introduction,Heavy Hex Bolt Manufacturers hopes that you can simply refer to the content of this article in future use.