Seersucker Fabric Manufacturers Introduces The Manufacturing Te


    Seersucker Fabric Manufacturers introduces the chemical manufacturing method of seersucker:

    After the cotton cloth is processed by scouring, bleaching, dyeing or printing, it is printed with sodium hydroxide paste, and then washed and dried in a loose manner. The part of the cotton fiber on the fabric that is affected by sodium hydroxide shrinks, the unprinted part does not shrink, and the cloth body forms bumpy bubbles; it can also be printed with a water-repellent paste, and then dipped in sodium hydroxide solution, stacked, Loose washing and drying. The part where the water repellent paste is printed on the fabric can prevent the oxidation

    The effect of sodium, and the unprinted part of the cotton fiber shrinks by the action of sodium hydroxide, causing the cloth body to form bumpy bubbles.

    The bubbles produced in this way can be aligned with the printed patterns. If paint or ice dye is added to the water repellent paste, it can also make the fabric produce colored bubbles. After the fabric is printed with a water-repellent paste, immersed in sodium hydroxide solution, it is immediately embossed, stacked, and loosely washed and dried, which can make the fabric produce regular bubbles that are neatly arranged.

    The raw material of seersucker is made of pure cotton or polyester/cotton yarn, and the density of the bubble warp is higher than that of the ground warp, or the bubble warp is made of strands and the ground warp is made of single yarn. When weaving, the let-off volume of the bubble warp is greater than that of the ground warp, and then the cell warp is dyed and processed loosely to form beautiful, uneven bubbles. Use the principle that cotton fiber encounters concentrated lye to increase the diameter and shorten the length.

    Through the above introduction, 3D Embossed Fabric Manufacturers that you can simply refer to the content of this article in future use.