Introduction Of Fluorinated Solvent Application


    Heating is undoubtedly a big event in winter, but it is really distressing to face electricity bills like running water. Some people say that air-source heat pump heating is very electricity consuming, and they don't want to be advertised; they are also veritable "electric tigers". In fact, it is not true. There are many factors affecting heating power consumption, which cannot be generalized. Next, the editor of Fluorinated Solvent will come here one by one.
       1. Housing area
      Whether heating consumes electricity depends on the size of the house. For example, the larger the house area, the higher the power of the unit that needs to be matched, and the more electricity it consumes;
      2, house insulation effect
       Whether it consumes electricity or not depends on whether the house’s thermal insulation effect is good or not, and the house’s reporting effect is directly related to whether the building’s structure, doors, windows, walls and storeys have thermal insulation;
      3, the quality of the air source heat pump host is good or bad
       There is a mixture of similar products on the market. Whether the product design is reasonable, the materials used, and the technology are all the fundamental reasons that determine the power consumption. Therefore, we should pay attention to this point when selecting models;
      4. Is the host selection appropriate?
    Because the selection of the host is appropriate, it is also a factor that is easier for everyone to ignore; for example, a large machine with a small room will definitely cost a lot; while a small machine has been working for a long time under bad conditions, the cost will also be high. .
      At this time, how should we choose? When we select the model, we choose the appropriate heating equipment according to the size of the space of our house. In addition, you can also consult customer service to inform your needs and listen to selection suggestions;
       5. System design
       Whether the system design is good or not, if there is no problem with the system selection, it does not mean that the whole system is reasonable; this is because the system also includes the host system and the end system. The end system is a radiator, a sealing plate or a floor heating, and the energy consumption is very different; the end has different requirements for the water temperature, and the required heat is naturally different.
       Generally speaking, floor heating has low water temperature requirements, followed by air plates, while radiators have higher water temperature requirements, especially traditional cast iron radiators;
      6, water pump size
      The consumption of water pumps also accounts for a large proportion. When choosing water pumps in the market, I like to choose the freshman model; because the water pump is small, the water can not reach the far end, resulting in uneven indoor temperature and poor comfort. The larger selection of water pumps increases energy consumption, but ensures the uniformity of indoor temperature. How to choose between the two requires a balanced choice.
       If energy consumption is limited, then choose a smaller pump; if limited to avoid indoor comfort, choose a larger pump. In fact, the effect of flow velocity on the end of radiation, like radiator and floor heating, is not as obvious as the sealing plate;
      7, host installation location
      Ensure that the air intake and exhaust are usually, and there is no obvious short circuit between the exhaust air and the intake air; the unit cannot be attached to the wall during installation, and a reasonable distance should be maintained. At the same time, it is necessary to avoid being affected by the dirty air flow; it is beneficial to clean the heat exchanger of the outdoor unit;
       8. Temperature setting
       To give a very simple example, the indoor temperature is 21 degrees Celsius and 24 degrees Celsius, there is a big difference between the two; when the room temperature rises by 1 degree Celsius, energy consumption will increase by 10%. Therefore, users want to save electricity and adjust the water temperature a little bit higher while meeting the temperature demand.
       Through the above brief introduction, I believe you have a detailed understanding of Chlorodifluoromethane R-22? In addition, after the installation is completed, do not turn on and off frequently; because frequent turning on and off will not save electricity, but will consume more electricity.